Hello Guest it is March 28, 2024, 06:20:02 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - toenee12345

Pages: 1
1
Modbus / Re: arduino for switch and led inputs
« on: September 06, 2014, 02:22:00 AM »
thanks daniell
I'll try an old ide,but i would appreciate any help you (or anyone) could give me.

Thanks

Tony...

2
Modbus / arduino and modbus software
« on: September 05, 2014, 01:51:34 AM »
Hi there, I am new to this forum but I have spent a bit of time looking for a sketch for an arduino to allow me to use it as a modbus interface.

When I have been reading posts there seems a lot of people say how they have everything working but I can not see a working example.

I have downloaded Shilling's code, altered it to work on the new IDE but could not get it to talk to the Mach software

I have downloaded zafarsalam's code and the FRO / spindle works fine but no digital inputs or outputs. I also followed mrprecise44 tutorial on how to alter zafarsalams code to use inputs, this sort of worked it took the inputs in as a holding register and I could not get it to act as a switch in brains.

I would really appreciate if someone could help me, I would realy like digital inputs and outputs , 0-5v out and 2 0-5 in. I am wanting to use either a arduno uno or mega,

I would like the arduino code and a sample of the brain and the modbus setting.

Again I would really appreciate some help with this

Tony......

3
Modbus / arduino for switch and led inputs
« on: September 05, 2014, 01:49:19 AM »
Hi there, I am new to this forum but I have spent a bit of time looking for a sketch for an arduino to allow me to use it as a modbus interface.

When I have been reading posts there seems a lot of people say how they have everything working but I can not see a working example.

I have downloaded Shilling's code, altered it to work on the new IDE but could not get it to talk to the Mach software

I have downloaded zafarsalam's code and the FRO / spindle works fine but no digital inputs or outputs. I also followed mrprecise44 tutorial on how to alter zafarsalams code to use inputs, this sort of worked it took the inputs in as a holding register and I could not get it to act as a switch in brains.

I would really appreciate if someone could help me, I would realy like digital inputs and outputs , 0-5v out and 2 0-5 in. I am wanting to use either a arduno uno or mega,

I would like the arduino code and a sample of the brain and the modbus setting.

Again I would really appreciate some help with this

Pages: 1