Messages

1

FAQs / Re: Setting Mach 3 Port to PCI parallel port address

« on: August 21, 2014, 09:51:04 PM »

Gerry,

Thanks. I can work with that info.

TMK

2

FAQs / Re: Setting Mach 3 Port to PCI parallel port address

« on: August 21, 2014, 06:11:24 PM »

Having a bit of the same issue. I installed a SIIG Cyber Pro Parallel Port into a Windows 7 machine with no parallel port on the mother. But notices that the IO Range for the 2nd line is lower than the 1st and does not show 8 bits.

LPT1
IO Range  D800-D807
IO Range  D400-D403
IRQ 0x00000013(19)

I have configured the port as LPT1 and starting address 0xd800. I have tried to run the Driver Test and only get the response "No Driver sensed installed. Run Driver Test".

Any ideas?

TMK