Hello Guest it is March 29, 2024, 03:55:18 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Lmecano

Pages: 1
1
General Mach Discussion / Re: Motor whistling only with Mach3
« on: August 14, 2014, 03:09:28 PM »
try retuning the motors.
hope this helps !

Do you mean try to modify stepper motor wiring ?!

2
General Mach Discussion / Re: Motor whistling only with Mach3
« on: August 14, 2014, 11:46:54 AM »
I have read the Mach3 documentation and... nothing.

Maybe a video could help to describe the problem,

https://www.youtube.com/watch?v=qWu4QUgrB1Y

3
General Mach Discussion / Motor whistling only with Mach3
« on: August 12, 2014, 04:36:02 PM »
Hello,

I have just built my home-made CNC and I have a set-up problem, I guess.

When I'm using my CNC with my manual interface, no noise. However, when I launch Mach 3 - it means I desactive the Reset button - my stepper motors make a strange noise. Even if that noise don't impede my stepper motor to work, it's quite... annoying.

Do you have any ideas where the problem could be ?


Thank you for your time !

Pages: 1