Messages

1

General Mach Discussion / Re: The Blue screen

« on: June 09, 2015, 05:06:56 PM »

Thank's for that was looking at the wrong script ,got the one with XY in  it now ,Thank's to all who contribute it has made my understanding of Mach a whole lot easier the more I use it the better I get.cheers John.

2

General Mach Discussion / The Blue screen

« on: June 09, 2015, 03:07:45 AM »

Hi ,sorry i posted in the wrong place hope this is rite.
So I have the Blue screen installed and was hoping to use the touch test centering ,when I hit the button it is traveling very slowly I was wondering where to change the speed in the script.I have the Z Plate offset at 8.0 mm and that is working fine at the size of my touch plate auto tool zero works as well ,just the slow speed on centering and + or - X & Y  .Hope someone can help cheers John.

3

General Mach Discussion / Re: BOB jumpers

« on: October 12, 2014, 03:23:08 PM »

Yes I sent a couple but I did not hear so went over to the other forum I think it may  be the board it cant be this hard 6 weeks

4

General Mach Discussion / Re: BOB jumpers

« on: October 12, 2014, 05:12:31 AM »

She still is a pain I wonder if the BOB is the issue.?

5

General Mach Discussion / Re: BOB jumpers

« on: September 26, 2014, 03:58:05 PM »

Hi, Yes used the schematic on his website EN-012 only change is a power supply doubler for the 2 power supplies running 4 steppers.here is a pic of the jumpers at the moment.

6

General Mach Discussion / BOB jumpers

« on: September 24, 2014, 11:52:24 PM »

Hi,I'm having trouble with the limit/home switches on my CNC home built,purchased a full licence for Mach ,have Geko g203v stepper drivers all was going well steppers drive, wired the Limit/Home switches so that if a wire is broken It should stop the machine,.After 4 weeks on and off trying to set the jumpers I am at a loss on how to set the board  to see the limit/ home switches in Mach .I have a Homann MB -02-V6 breakout board ,Hoping that some one may be able to shed some light on how I do this having already mastered this board ,i would be most grateful .

7

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: August 20, 2014, 03:41:07 AM »

Hi as well ,
My build has been a long time coming as with most it was going to be relatively easy and as many I guess have found it is a challenge to say the least .I have been lucky to have great support close by Homann Designs  great product ,I however don't have the electrical prowess but I am learning slowly along with mach 3 I think I need the tutorials on disc so as to watch them again and again for the things I have missed I will get there ,cheers all.