Hello Guest it is August 01, 2021, 10:03:51 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - gettinwet

Pages: 1
I will when I get home from work this evening. Thank you.

Good morning. I am setting up M3 with a Gecko G540. I am having an issue with my x and z axis while homing. The M1, M2, M3 lights all illuminate on the diagnostic screen when I manually activate the switches. However when I reference each axis the y is the only one that stops and backs up. The others dont stop I have to hit the e switch. I am using the xml file available from gecko. The link is to the schematic that I used for wiring. Thanks in advance for the help, Doug   


Pages: 1