Hello Guest it is May 28, 2020, 04:13:52 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - KundaWelding

Pages: 1
1
General Mach Discussion / Re: DTHS Issues
« on: July 26, 2014, 06:18:46 PM »
This is the G-code that my created drawing brings up when I open it in Mach3.  I'm not familiar with G-code yet but it would seem that there is something going wrong between the creation of the file and opening it in Mach3.  I apologize for my ignorance in this field but I am just trying to get any information to get started I can and I appreciate your time.

2
General Mach Discussion / Re: DTHS Issues
« on: July 26, 2014, 06:00:34 PM »
N0010 (Filename: Drawing1.tap)
N0020 (Post processor: ldr dthclV.scpost)
N0030 (Date: 26/07/2014)
N0050 F1
N0060 G53 G90 G40
N0070 G00 X0.0000 Y0.0000 Z0.6250
N0080 S900
N0090 M22
N0100 S10 (DTHC is off)
N0110 M22
N0120 M05 M30

Status bar shows that DTHC is off, and I noticed when the test runs it shows that the DTHC Min cut lenght is on and set at 1 units.  I think this may be a clue.

3
General Mach Discussion / Re: DTHS Issues
« on: July 26, 2014, 05:23:57 PM »
Thanks for the reply, having a different problem now.  All I want is for the table to run through a .tap file I create in sheetcam and open with Mach3.  The table responds to Mach3 when I load the test.tap file but will not respond to a file I create in Sheetcam with the same .tap extension.  Is there a setting somewhere that is not right or something that needs to be set before the Mach3 program will run the file I create?  On the G-code box it shows activity as if it is running through but the table doesn't do anything.  Also, there is no image of the cut shown in the preview box on the right that shows the xy axis. 

4
General Mach Discussion / DTHS Issues
« on: July 25, 2014, 08:17:18 PM »
Recently acquired a plasma cutting table running Mach 3 and I am just trying to get the table to jive with the computer.  I am attempting to run the G-code and I keep getting a DTHS setting issue.  I believe this is a digital torch height setting but I am very new to this whole thing and can't figure this out, please help!

5
Hello everyone, I am very new to the software and the industry.  I'm a sponge looking for any information that can help me.  Thanks everyone in advance.!

Pages: 1