Hello Guest it is March 29, 2024, 07:54:56 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - remo84

Pages: 1
1
General Mach Discussion / A parallel port problem with mach2/3
« on: May 30, 2007, 03:25:06 AM »
my cnc is already works on mach2 on my computer but when i change the pc to another it doesn't work for the same config.
so  i think that the problem is in bios config. for the parallel port so i make it exactly like that one who works put still not working.
so i reverse , i mean i begin to change the bios  config. for parallel port on the pc which cnc was already work on it, i find that it works for all parallel port configuration . so i don't know what is the problem.

2
General Mach Discussion / A parallel port problem with mach2/3
« on: May 30, 2007, 03:10:50 AM »
my cnc is already works on mach2 on my computer but when i change the pc to another it doesn't work for the same config.
so  i think that the problem is in bios config. for the parallel port so i make it exactly like that one who works put still not working.
so i reverse , i mean i begin to change the bios  config. for parallel port on the pc which cnc was already work on it, i find that it works for all parallel port configuration . so i don't know what is the problem.

Pages: 1