Hello Guest it is December 01, 2020, 01:04:35 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jwilliamsjj

Pages: 1
1
General Mach Discussion / Re: loading G code
« on: February 16, 2016, 08:52:47 PM »
Thanks, I will do first thing in the am.

2
General Mach Discussion / Re: loading G code
« on: February 16, 2016, 08:25:54 PM »
I did not notice any message there, but did not specifically look.

3
General Mach Discussion / loading G code
« on: February 16, 2016, 07:56:50 PM »
Today I ran several new files through Sheetcam exactly as I have many times. When I went into Mach 3 to bring the files in, one at a time, to cut, the G code would not load.  I few lines did load but it is not the G code for the files.  I was able to cut the files by going straight from Sheetcam into Mach 3 immediately upon saving the file after posting.  I then tried to load G code from previously cut files, some of which I have cut many times, with the same result.  I must have inadvertently changed some setting, but cannot figure it out.  When I click on the file name to download the G code, just a few lines appear, but they are not the G code.  Any help is appreciated.  Thanks

4
General Mach Discussion / Re: Assistance needed $$
« on: September 29, 2014, 11:42:00 AM »
Thanks, in this case there is plenty of room.  I have been struggling with this for weeks and am about to go mad.  I need to get my machine in operation.  I can do a simple, one with no sheetcam warnings, cut but am unfamiliar with using corel draw and my helper who knows corel draw, knows nothing about sheetcam amd mach3 and we have been unable to figure it out thus far.  I believe someone familiar with it all, could get me going quickly.

5
General Mach Discussion / Assistance needed $$
« on: September 29, 2014, 08:27:15 AM »
I need someone familiar with Sheetcam and Mach3 to help me get my drawings free from the "could not place leadins" and "all cut paths not generated" warnings and acceptable to Mach3. I will be glad to pay a good hourly rate. Someone within 200 miles of upstate SC would be perfect, if not we can work together by email. One-time help would be appreciated, but I would like to develop a long term arrangement beneficial to us both. Thanks.

6
General Mach Discussion / Help
« on: July 08, 2014, 01:00:54 PM »
I am in north western SC and looking for someone within a few hundred miles using Mach 3 for plasma cutting and/or routing.  I want to come look.  Thanks, any help appreciated.  Jimmy Williams  jwiljrj@netscape.net  803 533 8000

7
General Mach Discussion / Re: Hall of shame
« on: July 08, 2014, 10:12:15 AM »
Tweakie, I am new.  I went to the link you cited for this site and cannot figure how to post there.  Can you help with more soecific instructions?  Thanks  Jimmy Williams   jwiljrj@netscape.net

8
I am located in NW South Carolina and am setting up a system.  I would like to make contact with someone within several hundred miles who is using Mach 3. I will do mostly plasma cutting and maybe some wood routing.  Using CandCNC and Precision Plasma.  Please contact me at jwiljrj@netscape,net or 803 533 8000.  Thanks, Jimmy Williams

Pages: 1