Hello Guest it is December 16, 2019, 08:30:57 AM

### Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

### Messages - CG

Pages: 1
1
##### General Mach Discussion / Re: Direction of move XY in degrees
« on: June 25, 2014, 09:12:34 PM »
Thank you very much, once I had the correct terminology I searched again and found the answers on how to turn this function on, it works 100% to my requirement.

2
##### General Mach Discussion / Re: Direction of move XY in degrees
« on: June 25, 2014, 06:59:14 AM »
Thank you for the reply, I wiil try and explain.

Lets say the XY move direction of the cutter, for example a knive blade, is in travel direction 90°, then I want to asign axis A = 90°,same goes for if the XY direction change to 180° or if the XY follows an arc I want axis A to always follow the travel direction angle in degrees,  so for example if one move in a circular cut clockwise direction from  90 to 180° that A starts at 180 and follow the curve 181,182,183° etc to end up with angle A=270°?

3
##### General Mach Discussion / Direction of move XY in degrees
« on: June 25, 2014, 12:26:15 AM »
Hi all
I have been playing with Mach3 and before I complicate things wondered if there is a command available that gives the current direction of travel in degrees that I can assign to A axis?