Messages

1

General Mach Discussion / I almost cant READ THE GCODE ON THE MACH 3 WINDOW!!!!!!!!!!!!!1

« on: September 07, 2016, 02:39:28 PM »

PLEASE HELP I ALMOST CANT READ THE GCODE ON THE MACH 3 WINDOW, EVERY TIME I OPEN MACH 3 IT SEEMS TO GET SMALLER!! PLEASE, HOW ON EARTH CAN YOU ENLARGE THE GCODE THERE IS NOTHING ON THE FORUM. I CANT BELIEVE IT WHAT IS WRONG WITH THIS PROGRAME! IT IS SO FRUSTRATING!  THERE IS A PART TO ENLARGE THE FONTS BUT IT DOESN:T WORK!! PLEASE HELP A MACH 3 DUMMY!!!!!!!!!!!!!

2

General Mach Discussion / Re: Mach 3 Scaling Problem

« on: July 05, 2014, 11:39:50 AM »

Hi All,
I need to be saved once again! I was wondering if there is a way of scaling down in Mach 3. I tried playing with the scale figures on the main page and successful in flipping the image from left to right and so on, but if i enter -2 in the X and Y the image is all distorted. Any way i'm not bothered cause some kind soul will save me again!!
Best regards
Greg