Messages

1

General Mach Discussion / Re: E-stop and Probe problem

« on: December 29, 2014, 02:18:44 PM »

Well I do not know what caused it but I set all the pins involved back to inactive and 0. Then one by one I redid activating to devices and it seens to be fixing the problem.
I am rewiring tie Home switches and will auto set them when I am done. Hope this fixes it.

Don

2

General Mach Discussion / E-stop and Probe problem

« on: December 28, 2014, 05:17:51 PM »

today I started my machine and have the E-Stop called for . I cannot get it to reset. The probe led is also green and I cannot figure out why. I disconnected an e-stop switch and restarted Mach3 no luck. I disconnected the wires from the moveable and stationary probe plates and the ground also. No wires connected to the BOB. Still have a green probe led and a message probe active. Before I disconnected the probe wires I did touch them to see if that would fix it . No. None of the home switch led are lit. Home X,Y,Z does not work. I now have all wires from the BoB disconnected and still get the e-stop and probe active message. any ideas where to start looking '

Thank You
Don

3

Screen designer tips and tutorials / 2010 set Simplify the standard Screen

« on: June 09, 2014, 04:29:12 PM »

I have just started using the 2010 screenset. There are buttons I do not need. I would like to remove some of the things
I do not need. I am no programer . Are there any sets that people have made and can be downloaded I do not need
spindle control and there are a couple of others I don't need. There are also a few things I would like different icons
set for.

Thank You for your time
Don