Messages

1

General Mach Discussion / Re: 3020T estop not stopping the spindle

« on: May 25, 2014, 08:53:47 PM »

If you 3020T is like mine, there is no control over the spindle other than the manual ON/OFF switch provided on the front panel of the controller itself. 

2

Forum suggestions and report forum problems. / Re: Cannot Complete New Forum User Registration Using Internet Explorer

« on: May 25, 2014, 08:46:20 PM »

Tried to register as a new user of this forum using Internet Explorer v11, but could not complete (sliders under the Captcha pictures would not move).  No warnings appeared (e.g. "You need to enable JavaScript and allow temporary cookies").

They did move in Google Chrome.

No reply desired.  Just FYI.

Had the same problem.  Loaded Firefox just so I could register.  I did have JavaScript enabled and those cookies allowed under MEDIUM security.