Hello Guest it is March 28, 2024, 02:00:23 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Robertwf

Pages: 1
1
General Mach Discussion / Re: Port 1
« on: May 25, 2014, 05:33:32 PM »
GER 21,
Thanks for that tidbit of useful information.  I will use it today

2
Hi Hood, I don't know what an XML is or how to h\get one (:

3
General Mach Discussion / Port 1
« on: May 24, 2014, 06:49:06 PM »
 :-[
Hi all, I am running into a small problem.  I cant use the normal Port 1 for Mach 3 because it is used up by the mother board.  So I need some guidance as to what course of action I should take

4
Hi Hood,
Thanks for responding to my post.  You brought an interesting point.  My computer has Port 1 taken up by the Mother board.  I waqs wondering if you had any ideas?  Thanks

5
I recently Purchased a Sanven 6040 desktop CNC through Amazon.  I set it up and was able to Jog by using the arrow keys .  I tried to set the X, Y and Z zeros now The DRO's show movement but the stepper motord\s don't budge an inch. Has anybody else experienced this and if so what did you do?
Thanks

6
Hi my name is Bob. I am new. I have a problem with my Sanven 4axis 6040 desktop cnc. When I try to move (jog) my motors the DRO's move but motors don't . Can somebody please provide some direction?  If I had any hair I would have pulled out by now
Thanks

Pages: 1