Hello Guest it is November 24, 2020, 04:30:22 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Shaun83

Pages: 1
1
General Mach Discussion / Re: Newbie
« on: May 03, 2014, 04:15:31 AM »
:/ brilliant thanks for you help I'll check it out soon as I'm back home, The guy I bought it from seems very genuine, and has been on the phone a few times, so I doubt he would of sold me a dud, but hey never know,

I'm hoping it's a dodgy cable,

Just to clarify, when everything is powered down should the motors move freely??

2
General Mach Discussion / Re: Newbie
« on: May 03, 2014, 02:32:30 AM »
No the cannot be turnt

4
General Mach Discussion / Re: Newbie
« on: May 02, 2014, 07:36:09 PM »
Hi there it's a dongda ts series

5
General Mach Discussion / Re: Newbie
« on: May 02, 2014, 06:50:58 AM »
Yeah sure soon as I'm home ill post detials

6
General Mach Discussion / Re: Newbie
« on: May 02, 2014, 06:35:32 AM »
Thanks for reply, correct, using a PC with winxp
As far as I'm aware all configuration is basically set as
The tutorial states on the videos on this site??

7
General Mach Discussion / Newbie
« on: May 01, 2014, 07:05:13 PM »
Evening people excuse me if I'm in the wrong place

First thing, is to introduce myself I'm shaun from plymouth ( hi )

Secondly, the cnc world is very new to me so please be gentle :)

Thirdly, GOOD GOD!!!!
Having a melt down to say the least..... Just bought a cheap cnc machine with out knowing anything about them.....it works :) well ish lol

Gone through the tutorial online, spindle is spinning away however I cannot get the axis's moving what so ever?? Where do I start please

Pages: 1