Hello Guest it is March 28, 2024, 01:25:05 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - alnicov

Pages: 1
1
General Mach Discussion / Re: cursor keys not working
« on: March 08, 2006, 02:46:37 PM »
Oh...I mistook slow jog rate for jog step increment.   Still don't know how that got changed but it's all better now.  Thanks to you both and have a happy St Patty's Day.... Slainte!

Steve

2
General Mach Discussion / Re: cursor keys not working
« on: March 08, 2006, 12:41:46 PM »
Hi Gerry,
Jog mode is on.  Incremental jog works OK but continuous jog does not work unless I use the shift key with the arrow keys.   Is there a setting that needs to be changed?  Perhaps the keyboard map has somehow been altered.

Steve

3
General Mach Discussion / Re: cursor keys not working
« on: March 08, 2006, 08:13:42 AM »
It is in IJ incremental and the jog rate is .1000.  I switched IJ mode to absolute in the config/setting window but still no change.   Is there another setting that I'm missing?

Steve

4
General Mach Discussion / Re: cursor keys not working
« on: March 07, 2006, 04:59:07 PM »
Hi Brian,
  Yes, it works with shift and arrow keys!

5
General Mach Discussion / cursor keys not working
« on: March 07, 2006, 12:45:07 PM »
I posted this problem in the CNCZone forum and so far have not found a solution.   I'm using Mach2 and am not getting any manual movement of the axes with the cursor keys.  Everything else works fine; MDI, screen joystick, and program mode.   I've increased the pulse width and reloaded the latest version of Mach2 and the driver.  Ran the OCX test and came up blank.   Any clues?  Thanks in advance for any help you can give.

Steve

Pages: 1