1
General Mach Discussion / Re: Table display
« on: April 26, 2014, 10:58:13 AM »
Thanks Gerry,
When I try to use the ref on axis x and y the gantry wants to run off the table.Is this due to the soft limits being incorrect and do you know a good tutorial on how to set them properly ?
Thamks agian!
When I try to use the ref on axis x and y the gantry wants to run off the table.Is this due to the soft limits being incorrect and do you know a good tutorial on how to set them properly ?
Thamks agian!