Hello Guest it is July 26, 2021, 10:25:13 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - SolarImages

Pages: 1
1
FAQs / Tool path dsiplay
« on: December 15, 2014, 01:44:07 PM »
I am new to Mach 3 and i am currently running through the Tutorial video's. In the tool path display what are keys used to zoom/pan/etc in the tool path window? I can reset the view and do the axis rotate but nothing else thank you for your help!

2
General Mach Discussion / Re: At the risk of feeling retarded
« on: November 29, 2014, 11:57:42 AM »
Thank you for that clarification!

3
General Mach Discussion / At the risk of feeling retarded
« on: November 29, 2014, 11:25:58 AM »
So I am very new to the CNC world in Terms of actually making sending a design from my computer to Mach3 o be cut.

I use Artcam for my design software and Mach3 for G-code to the machine.

My question is about Post Processor's I have seen mention of them many times and have googled them quite a bit.
I understand there function but most of what i have read is a explanation that leads me to believe i need another piece of software?
I think i have a post processor in Artcam Insignia that creates the G-code (toolpath) Once i have this i believe i just load it into Mach3 and start the machine up and go? Thanks for any clarification on this cheers!

4
Hey Everyone I have owned mach 3 for a few months now finally got my machine running (minus limit switches)

Great software!

Working on getting a PS3 controller working next, then the Auto Z tool touch off bit working, then the limit switches.

Built A platform CNC kit. Cheers!

Pages: 1