Hello Guest it is March 29, 2024, 07:10:10 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ganadero

Pages: 1
1


news about my failure friends;

I've noticed that when I do .tap code in the computer workshop, causes me this fault and when performed on my home computer all going great some friends could tell me i know the reason i use SHEETCAM

tanks very much my friends

2
Each machine will be different and when using steppers it is just a case of trial and error to find the correct velocity and acceleration.
Hood

tanks very much HOOD 

this week will try to solve that problem, because it is impossible to work with such failure

3
HELLO hood;

you are very kind to take time to help

 my cnc kit is a bladeruner of candcnc.com the current configuration of the motor is:

X AND Y: STEPS PER INCH 979.42, VELOCITY 500, ACCELERATION 35
Z: STEPS PER INCH 10,000, VELOCITY 100, ACCELERATION 35

can you give me an advice about the changes that you think suitable for this configuration?

4
General Mach Discussion / misalignment of Y axiz in plasma cutting table
« on: December 04, 2014, 01:50:06 PM »




misalignment of Y axiz in plasma cutting table

Postby LEO » Thu Dec 04, 2014 2:22 pm
HELLO GUYS

A few months ago finalize my project in a plasma cutting table 5x10 ft, my compressor capacity was very small so I could only make continuous cuts of 3 minutes Now I have a compressor 80 gallon thing is very different there has been a great problem after 7 or 8 minutes of continuous cutting the y axis misalignment around 3/8" I tightened the screws on the gears and racks all is well fixed , I reviewed mach3 settings and everything is the same in the two motors that move the Y axis someone something happened thank you very much for your support

add pics

5
nice job my friend

6
 tanks my friend,,

I have in my machine stepers, Then every time I turn on my machine I need to manually reference the home?

7
 hello guys;

I'm about to finish my first plasma cutting machine, the axes move in all directions a person it  was advised that it was not necessary to limit switches but I find it hard to understand how you will reference the machine without these I was told that by setting homing / limits but took a week and I can not, do someone can help me


 ;) ;) ;) ;)

8
Spanish / Cero máquina
« on: May 17, 2014, 11:54:41 PM »
Hola que tal colegas

Estoy  en la fase de pruebas de mi mesa de corte con plasma aún no pienso en ponerle microswitch para los límites, mi pregunta es como hacerle con mach3 para ubicar la máquina en home? Al no tener micr

oswich en los límites.

Gracias por su apoyo

Pages: 1