1
General Mach Discussion / Re: Z calibration all along y axis?
« on: April 08, 2014, 05:56:19 PM »
Thanks for all your replies, it looks like there isn't a simple way to do this in software. Was kinda hoping there was a calibration wizard (like a touch screen crosses) that i could use my height touch tool.
Can't really machine a spoil board flat as its only a dremel cutter but i spose i could always use shimms to correct a spoil board to the correct height.
I think im going to have another go at getting more level mechanically first . But many thanks everyones advice
Can't really machine a spoil board flat as its only a dremel cutter but i spose i could always use shimms to correct a spoil board to the correct height.
I think im going to have another go at getting more level mechanically first . But many thanks everyones advice