Hello Guest it is March 29, 2024, 06:20:15 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gnomic

Pages: 1
1
Newfangled Solutions Mach3 Wizards / Re: Gear Cutting with 4th Axis
« on: November 14, 2016, 06:33:17 PM »
I must be a moron but in the gear cutting wizard, which number do you use to cut blank from the right (behind).
What settings would you use to cut 1 inch blank with 30 gears. Going right to left from the back.

2
Trying to set up steps. Units set to inches. If I put in 1" it moves about 1/20. If I put in 20 it moves one inch? Yes I am a moron. Any info. Appreciated.

Pages: 1