Messages

1

General Mach Discussion / Re: Problems With homing out the machine.

« on: March 20, 2014, 04:00:21 PM »

"Dir active state"  are you speaking on a directory and if not or so, where would I find the "Dir active state"

2

General Mach Discussion / Problems With homing out the machine.

« on: March 16, 2014, 07:14:28 PM »

Machine: Minitech 5 Axis Mill 

Software: Mach3


Im currently having problems with homing out the machine with the mach3, when I zero out the machine and home all the axis "X,Y,Z,A,B", I will move the axis for the home position that I have them set at and run the G-code,   G28 X0 Y0 Z0 A0 B0  to test the machine to go to the home position that i set it at. and it will go to the home position that I set it at, but when I run the test again G28 X0 Y0 Z0 A0 B0 after moving all the axis it doesn't bring it back to the home position that i set it at it a little bit of on all the axis