Hello Guest it is November 13, 2019, 05:04:01 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - daryn

Pages: 1
1
General Mach Discussion / Re: Stopping Distance
« on: April 03, 2011, 03:53:57 PM »
Thank you Tweakie and RICH, guess I'll have to do some testing first.
Regards Daryn

2
General Mach Discussion / Stopping Distance
« on: April 01, 2011, 12:42:06 AM »
I am trying to ascertain the stopping distance I should allow for two conditions on the router I am constructing.
Currently it is not up and running yet so I cannot do exact tests.
The basic configuration consist of a 1604 ball screw with a size 42 stepper. I have a 1:2 reduction timing pulley
between stepper and ball screw. I would like to ask users based on their experience. If the axis is running at
a high  speed (whatever that may be) and the 1) Mach soft limit or 2)Electrical Over travel limit are triggered
independently how much mechanical gap should I allow to prevent the gantry smashing into the end of its stroke?
In a nut shell how fast will the axis stop moving and how far would the gantry travel when the stepper is stopped in the two conditions?
Does the momentum play a part? Thank you for your valuable input. Regards Daryn ???

3
Competitions / Re: ******Guess and win a G100 Grex******
« on: May 24, 2007, 02:56:27 PM »
2,767,235 chips !
Daryn

Pages: 1