Hello Guest it is March 29, 2024, 08:50:09 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - snapajap

Pages: 1
1
General Mach Discussion / NEWBIE!! How to round an edge
« on: January 28, 2014, 11:29:39 PM »
Ok, so I'm all proud that I have cut out a rectangle made of plastic and it has rounded corners.  I have been trying like crazy to make the outside edges have a rounded edge (without taking to my router table).
Is it a roundover, fillet, bevel??  How can I incorporate this into my NFS programming? 
I'm pretty dumb in this whole arena, so, bear with me please.
Thank you in advance.

Pages: 1