1
General Mach Discussion / Re: Port Pins Current State not functioning.
« on: January 22, 2014, 11:01:52 AM »
My IR sensor hooked to the spindle drive pulley registers high, or used to, every time the foil tape passed under it. I wrote a program to interpret the signal as a count +1 and when count =100 to stop the spindle.
I'm not in the shop right now so I can't send you my xml, but even if I were, I wouldn't know how. As I said I'm quite green, so please forgive me.
Sent from my HTC One using Tapatalk
I'm not in the shop right now so I can't send you my xml, but even if I were, I wouldn't know how. As I said I'm quite green, so please forgive me.
Sent from my HTC One using Tapatalk