Messages

1

Brains Development / Re: How to use Modbus data as axis data

« on: January 12, 2014, 05:01:36 PM »

Thank you for your reply. After reading manuals and visiting forum messages, i found that. Mach3 is not for closed loop systems. Now i am trying Linuxcnc.

2

Brains Development / Re: How to use Modbus data as axis data

« on: January 07, 2014, 07:40:59 PM »

here is my encoder valu sent by modbus. i can see encoder value here and x encoder position value.



however i want to see encoder value with x axis value updated automatically


if i click on Load to DRO encoder value goes to x axis DRO.

How can i do encoder value automatically loads to X axis DRO?

Helps are appreciated.

3

Brains Development / How to use Modbus data as axis data

« on: January 06, 2014, 06:25:55 PM »

I have a siemens s7-200 cpu 224xp connected to 2 rotary and 1 linear encoders. I send these data over modbus to mach3. I see data at brain control. How can i use these data as X, Y and Z axis data?