Hello Guest it is March 28, 2024, 08:29:59 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hrlaust

Pages: 1
1
Mach4 General Discussion / Re: Mach4 Printer Port Discussions
« on: June 18, 2014, 04:48:25 AM »
Thanks Art.

Another issue which is probably just M4 v.1767 related and maybe not of interest here but I am just reporting as I find.

In Imperial mode everything is OK but in Metric mode G00 X1 Y1 Z1 moves X,Y,Z axis 1mm whereas G00 A1 moves the A axis 25.4mm (all DRO’s reflect the correct physical movement).

Tweakie.


I just tried in the 1817 version and I get the same result when you move the A-axis. Also the feedrate is 2,5 (not 2,54) times larger than the feedrate I have set. This only affects the A-axis.

Pages: 1