Messages

1

Share Your GCode / Searching for zodiac *.dxf files

« on: December 26, 2013, 06:16:19 PM »

Hi,

Does anybody have complet zodiac in dxf. I would like to cut them in aluminium.  I am looking for 2D shapes.

TNX

G

2

Share Your GCode / Re: lego block just for kicks.

« on: December 26, 2013, 06:07:34 PM »

Thank you. Did you try to cut this lego file? If you did can you please post foto. I am still strgeling to do this job.

G

3

Share Your GCode / Re: lego block just for kicks.

« on: December 26, 2013, 11:50:00 AM »

Hello,

Can you please tell me which program you use that extension of file hase *.nc?

thank you,

best regards, G

4

Share Your GCode / Re: mac logo

« on: December 26, 2013, 11:40:43 AM »

Hello,

which program you use that it have exstansion *.nc.

Thank you for answer.

Best regards, G

5

FAQs / Re: Mirror milling

« on: December 23, 2013, 01:35:20 PM »

It works Eureka. Thank you veary much once again.

Do you mybee know how to kontrol spindle in PWM mode. if I have on PWM mode it runs on full speed. komand M5 doesentz help.

You aree the men!!!!
Thanks once again on help.

Best regards,

Gregor

6

FAQs / Re: Mirror milling

« on: December 23, 2013, 12:57:28 PM »

Thank you. the first letter word the mill make ok other again in mirror state.

7

FAQs / Mirror milling

« on: December 23, 2013, 10:15:33 AM »

I have mange to start cnc from China. But it mills teks wrong way. I am not DaVinci, so I would like to repair this. Does somebody knows whath to do.


Please help