Hello Guest it is March 29, 2024, 05:53:31 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Splinter1421

Pages: 1
1
That seems to have worked.  We still have some issues with the machine stopping but the hourglass is gone and still no error message.  So we are going to upgrade our cabling.  Thank you again!

 

2
Thanks Gerry - Will check it out asap....

3
Good Morning -

We have recently built a CNC using Mach3, Kflop card, and running on XP. We are having a problem where the machine will stop with no error message.  We have run the program several times thru with no problems but on the 3nd or so run the machine just stops.  The last time it occurred two heads (Z & A) were moving down and one spindle stopped, the other kept spinning.  Also the spindle height distance was different and it should have been the same. There is no error message. The hourglass on Windows XP spins until we reset the whole thing. 

Thank you in advance for any suggestions.....

Nancy

Pages: 1