Hello Guest it is November 27, 2022, 08:03:40 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - silvermine

Pages: 1
1
General Mach Discussion / New Hermes IS400 Volume
« on: May 19, 2007, 01:18:54 PM »
Does anyone know if I can control a New Hermes IS400 Volume as a 4 Axis CNC machine?  Does the Mach 3 work on this machine?  If so, does anyone have the setup data for it.

Thank you,

Ralph

Pages: 1