Guest
Show Posts
1
General Mach Discussion / Re: Backing off homing switches
« on: November 17, 2013, 01:50:51 PM »
I have a problem with auto homing. I installed a set of npn prox switches. I used the pmdx 126 boart, the 134 mother board, and gecko 203's. I configured everything correctly
and get all the lights for x,y, (z is not being homed) The machine begins with the Y axis homing and reaches the switch and stops and backs off. Then the x axis homes towards
the switchs, the A axis (slaved axis) hits the switch and backs off, the x- hits the switch, backs off, and continues to ram in a back and forth fashion? What am I doing wrong?
and get all the lights for x,y, (z is not being homed) The machine begins with the Y axis homing and reaches the switch and stops and backs off. Then the x axis homes towards
the switchs, the A axis (slaved axis) hits the switch and backs off, the x- hits the switch, backs off, and continues to ram in a back and forth fashion? What am I doing wrong?