Hello Guest it is March 28, 2024, 03:11:04 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - owilba

Pages: 1
1
when moving  X- 16.0000...it (X) moves one inch.....how to re-configure !??? I have above system , but in inches......

2
Trying to configure the steps per unit (inch) on my Taig CNC with StepmasterNC 4- axis controller (model SOP-2 )

The screws are 1/2" x 20TPI

Steppers are Sure step 276 oz 2.8A 1.8degree step (200 steps) 1/8th step microstepping

Units in Mach 3 are inch
 how is this figured...
 my test comes up "pulsing too fast....and where in Mach3 do I input these #rs ???

3
can you figure this in inch !!!  i have same set up...running test, shows pulsing too fast !!

4
General Mach Discussion / Re: Motors not responding
« on: November 14, 2013, 07:28:56 PM »
need machx lisence and paperwork/instructions   help

Pages: 1