1
Mach3 under Vista / Mach 3 and win 7 crash and blue screen
« on: November 14, 2013, 02:37:12 PM »
Hello everyone I am new at cnc world and I am so confused.i set up my cnc and a pc which run a fresh format of win7.the problem is that at first I run my cnc ok and did some cuts,but after a few days my hard disk had problem and I buy a new one,so I setup win 7 again and mach 3 but this time after installing the driver test when I try to open mach my computer crash to blue screen and restart itself.when I delete driver test it open normally but no axis moving?sorry about bad English,what do you thing?