Messages

1

LazyTurn / Re: LT gcode diameter larger than needed

« on: February 14, 2015, 04:27:05 PM »

  HI,
I encountered a problem when transferring autocad drawing to lazy turn. the diametre is more bigger than required.!
can any body help me please ?
Please check attachment for more explanation.

2

LazyTurn / Re: LT gcode diameter larger than needed

« on: November 17, 2013, 02:50:10 AM »

guys,
I think that I find the solution, I was playing with setting and changed accidentally the mode from Radius to Diameter. So after I change it the problem was solved.
Thanks every body.

3

LazyTurn / Re: LT gcode diameter larger than needed

« on: November 16, 2013, 09:00:52 AM »

Friends,
One more project with identical problem.
Please check attachment.

4

LazyTurn / Re: LT gcode diameter larger than needed

« on: November 16, 2013, 07:50:26 AM »

 Rick,
I'm just back home. kindly check attached .DXF file saved under AUTOCAD R12 version.
 

5

LazyTurn / Re: LT gcode diameter larger than needed

« on: November 16, 2013, 06:58:27 AM »

OK Rick,
I'll do it asap (because I'm at work right now)

thanks

6

LazyTurn / Re: LT gcode diameter larger than needed

« on: November 16, 2013, 02:00:05 AM »

dear Rich,
I dont find extention .12DXF
I have DXF (autocad 2010,2007, 2004, 2000, 14 )
does .DXF means (DXF autocad 12) ?

7

LazyTurn / Re: LT gcode diameter larger than needed

« on: November 15, 2013, 05:00:56 PM »

Dear Rich,
please check attachment, and for info this broblem happen for all tests that I do.
when transferring from AUTOCAD to LT all ok. but when posting from LT to Mach 3 the Diameter of the ROUGH path looks clearly more bigger than the FINE path.

8

LazyTurn / Re: roughing job away from workpiece, finishing job is fine

« on: November 15, 2013, 04:37:10 PM »

yes I finish reading it
but may be I messd some details .

9

LazyTurn / Re: LT gcode diameter larger than needed

« on: November 15, 2013, 01:09:38 AM »

I have same problem.
what that means ? and what is the solution ?

10

LazyTurn / Re: roughing job away from workpiece, finishing job is fine

« on: November 15, 2013, 01:05:17 AM »

hi,
I encountered the same problem. did get the solution ?