Messages

1

CS-Lab / servo motors feedback resolver

« on: November 25, 2014, 08:46:53 PM »

Hi

I need a help ...i have a old cnc and i need to change the drivers ....my motors is servo motor 3 phase  400V  with feedback resolver   ... can you help me to chose the good driver for these motors ...i would like to connect it to sc-lab controllers ..

Thanks

2

CS-Lab / Re: water and auto length tool

« on: July 14, 2014, 10:20:48 AM »

i changed my post processor in Art cam

T[T]
M6


Now which script of button i need to change  ...do modify  the procedure of M6   ..... Now i just have yellow led flashing and message : Press CycleStart
I not see the button tool change on mach3 i see just auto tool zero .... i think M6 is not for auto tool zero button

3

CS-Lab / Re: water and auto length tool

« on: July 13, 2014, 06:13:08 PM »

hi
you tell me  that i need to add a  M8 to my g-code ...but i use Artcam to generate a g-code ... can it do this automatically

4

CS-Lab / Re: water and auto length tool

« on: July 13, 2014, 05:46:29 PM »

yes it is a solenoid valve 120Vac 4w   ... 

5

CS-Lab / water and auto length tool

« on: July 13, 2014, 09:37:06 AM »

Hi

I have one question how i need to wire my switch (water )   to   cs-mio   and i would like to stop water when my cnc go on my auto length tool  and active water when it quit my auto length tool  ?

Can you help me .

Thanks

6

CS-Lab / Re: mach3 over read and csmio-ip-a

« on: July 03, 2014, 07:59:12 AM »

what is when led not flashing and what is when led flash

7

CS-Lab / Re: mach3 over read and csmio-ip-a

« on: July 02, 2014, 01:53:42 PM »

i can never got the green led

8

CS-Lab / mach3 over read and csmio-ip-a

« on: July 02, 2014, 11:08:34 AM »

Hi
i every time have light red on when i change speed in feed rate  .... if i click on reset i have 100% and not led green and no led red ... when i change  up or down speed ...i got a led red ?

thanks

9

CS-Lab / Re: tuning motors

« on: June 22, 2014, 05:30:38 PM »

non every  time  it detect the switch limit and go into reset

10

CS-Lab / Re: tuning motors

« on: June 22, 2014, 10:12:06 AM »

i think it is my problem     form user guide csmio
what is the solution ?   the HV disable my motors if limits is activated ?

10.9.5.2 HV Enable
In this place you can – for any CSMIO/IP con-
troller output – assign a function of main voltage activation (e.g. for servo drives). In many alarm situations like e.g. E-STOP signal activation, additionally main supply disconnection it may increase security level.
Output defined as „HV Enable” will be active during normal work of CSMIO/IP controller, in case of any alarm situations, such as limit switch or E-Stop touch, the signal will become inactive.