Messages

1

General Mach Discussion / Re: when running part wanders to the right cutting comes back to zero off that amoun

« on: October 23, 2013, 08:05:17 AM »

okay that helped some cut problem in half played with it some still cant get it all the way little under an 1/8 toward end of run and off at home i did swap drive motors and 6410 drives its axyz 4008 table

2

General Mach Discussion / Re: gcodes veering to the right when cutting return to zero is off that amount

« on: October 22, 2013, 11:04:03 AM »

I put 2*3.5 vinyl rail to route pkt holes the more holes I route the more my hole are routed to the. Right of center whatever my holes are off my home is off the same amount and it is consistent. Y axis only to the right tuned motor different settings. And recalibrated!

3

General Mach Discussion / Re: when running part wanders to the right cutting comes back to zero off that amoun

« on: October 21, 2013, 02:54:08 PM »

slowed everything down in motor tuning still get same results even on dry run
running on axyz 4008

4

General Mach Discussion / Re: when running part wanders to the right cutting comes back to zero off that amoun

« on: October 21, 2013, 01:44:45 PM »

what is the proper fix im kinda new at this

5

General Mach Discussion / gcodes veering to the right when cutting return to zero is off that amount

« on: October 21, 2013, 12:44:11 PM »

cutting holes wants to veere to right every time 1/16 then to 1/8 when back to zero its off that amount have to zero every time help please
mach3 with axyz 4008 table

6

General Mach Discussion / when running part wanders to the right cutting comes back to zero off that amoun

« on: October 21, 2013, 12:21:40 PM »

the more holes i cut the more y veeres to the right when back to zero its off that amount to the right any suggestions