Hello Guest it is March 29, 2024, 07:25:03 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - master_bebe

Pages: 1
1
thanks. i appreciate it.

2
General Mach Discussion / How to make Mach3 jump up uppn pressing ESC
« on: June 02, 2015, 12:17:43 AM »
sometimes, when a problem is detected while milling, i have to stop the milling.
when pressing the ESC button, the spindle just stops and stays buried inside the material.
is there a way to make it move up (in Z) for 10-20mm automatically after pressing the ESC button ?

Sincerely, Guy.

3
General Mach Discussion / how to override feedrate ?
« on: October 21, 2013, 12:32:33 AM »
Hi, it seems that the bars in mach3 in the override feedrate are not doing anything.
is there a way to enable/ disable it ? i'm moving the all of the sliders up and down and even trying to type a different value and nothing seems to work...
i can't even change RPM...
all of this while milling...

thanks in advance.
Sincerely, Guy.


Pages: 1