Messages

1

LazyCam (Beta) / Re: japanese font can't be used

« on: February 04, 2009, 05:33:21 PM »

What is a 11/12 ASCII dxf? Is ther any difference between a 11/12 ASCII dxf and just dxf?
I tried to import dxf file which I made by visio. But I couldn't see any charactors on LazyCam.

2

LazyCam (Beta) / japanese font can't be used

« on: February 02, 2009, 03:32:13 PM »

I'd like to use Japanese font on LazyCam.
I can see Japanese font name on font window when I select "TEXT" tab.
But Japanese charactor can't be dragged. 
Could you tell me how to do.

3

General Mach Discussion / Re: no step pulse

« on: May 26, 2007, 05:28:18 PM »

After Special Driver was installed, jogging operation doesn't work. DRO for axis position is freezed.

Thanks for your replay.

k.kuramochi

4

General Mach Discussion / Re: no step pulse

« on: May 26, 2007, 03:43:54 AM »

I installed SpecialDriver but after that jog operation doesn't work.  DRO of position freezes.

Thanks for your reply.

k.kuramochi

5

General Mach Discussion / Re: no step pulse

« on: May 25, 2007, 06:40:45 PM »

I use Port#1(0x378).
X Axis's step pin#=2, dir pin#=3.
When I check or uncheck the active Low setting on the motor outputs page, I can't watch any change of the step and the dir signals.

k.kuramochi

6

General Mach Discussion / Re: no step pulse

« on: May 25, 2007, 06:26:51 PM »

I have tried two kind of PCs.  Those are Dynabook(Toshiba) and ASUS mother board(P5VDC-MX).
The status is same each.
Thanks for your reply.

k.kuramochi

7

General Mach Discussion / Re: no step pulse

« on: May 25, 2007, 06:50:29 AM »

Oh another thing, make sure your scope is working, there should be a calibration poit on the front, when you put the probe on that and set the volts and timebase to the correct ranges you should see a nice square wave.
Hood

There is no problem for using a scope.
Before the mach is started, step signal is 0V.  After the mach is started, step siganal become 5V, but there is no change during joging.  The DIR signal is always 0V in back jog, forward jog and during ta est G-code program is running.
Thank you for your reply.

8

General Mach Discussion / no step pulse

« on: May 24, 2007, 11:18:31 PM »

I am trying to use machmill. 
I am observing stp & dir pulses by an oscilloscope but I can't see any pulses.

please teach me why.