This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - grsfldflyer
Pages: 1
1
« on: December 12, 2022, 07:35:53 AM »
I found that in Mach4 g-code with M62 P# will lock up intermittently.
anyone else seen this?? I would recommend not using Windows 11 Pro.
Arc-Ok came on and stayed on until arc went out due to peirce hole to large.
I loaded the old Mach3 Files and machine does not stop until finish with G-code so I don't belive its a noise issue.
2
« on: December 10, 2022, 09:28:57 AM »
I found that in Mach4 g-code with M62 P# will lock up intermittently.
anyone else seen this?? I would recommend not using Windows 11 Pro.
3
« on: August 27, 2020, 08:57:27 AM »
I have had the same issue. Reported it to support. No resolution yet... I'm going back one rev. to see if it works ok.
4
« on: May 13, 2016, 01:27:12 PM »
Dryrun.
Pages: 1