Hello Guest it is August 14, 2020, 01:07:14 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Don Momo

Pages: 1
1
General Mach Discussion / Re: Binding when homing at 100% speed
« on: August 28, 2013, 01:49:50 PM »
sure

2
General Mach Discussion / Binding when homing at 100% speed
« on: August 28, 2013, 06:47:36 AM »
Hi,

since I set up my mill I have this problem that X,Y and Z axis will bind when going for reference at speeds higher then 40% of max speed.
I do not have problems with max speed (1200mm/min) and acc (700mm/sec^2) when jogging on the BF20L, but when homing this problem occurs.

Is there a solution to this?
Thanks!

Pages: 1