Messages

1

General Mach Discussion / Re: Rookie Question

« on: August 19, 2013, 09:15:22 PM »

Not going to turn this a battle of wits, I cant agree more with your analogy, just do me a favor and work on your delivery.

2

General Mach Discussion / Re: Rookie Question

« on: August 19, 2013, 08:42:37 PM »

Thanks for the info. However, being an educator, I would recommend that you improve your communication skills so you can stop sending mixed messages. Think about your response from my point of view...

3

General Mach Discussion / Re: Rookie Question

« on: August 19, 2013, 07:43:01 PM »

Woah, I was hoping for a bit of advice, not a pile of sarcasm. Sorry for the stupid question, just trying to learn here.

4

General Mach Discussion / Rookie Question

« on: August 19, 2013, 07:04:44 PM »

I am creating a simple profile using SolidWorks and SolidCam, when I create the NC file and open it in Mach 3, I get these crazy big green circles? They don't show up in SolidCAM simulate, but they do in the preview window. Any suggestions?

[