Messages

1

G-Code, CAD, and CAM discussions / Mach 3 and THC Proma problem

« on: August 24, 2013, 11:48:08 AM »

Hey everybody...

Well, here I am again... because the only thing that keeps me from cutting parts is: I have all the systems running, except it appears there's no comunication between my THC and the mach 3, I put my THC in test mode and the mach 3 detects it, but there's no movement at all in the Z motor, am I missing something?
Can anyone help me?

Thanks.

2

Mach Screens / Re: g code editing

« on: August 18, 2013, 08:14:09 PM »

Well, here I am again... because the only thing that keeps me from cutting parts is: I have all the systems running, except it appears there's no comunication between my THC and the mach 3, I put my THC in test mode and the mach 3 detects it, but there's no movement at all in the Z motor, am I missing something?
Can anyone help me?

Thanks.

3

Mach Screens / Re: g code editing

« on: August 16, 2013, 02:36:30 AM »

I've just archieved what I needed, thank you so much Sam!!, I'm in debt with you, if there's anything i can help you with, just let me know, you can find my email here...

Best regards,
Victor.

4

Mach Screens / Re: g code editing

« on: August 16, 2013, 01:34:19 AM »

Ok, in the address says: C:\WINNT\NOTEPAD.EXE, does it sounds familiar?, thanks for your time!

Regards

5

Mach Screens / g code editing

« on: August 15, 2013, 08:34:59 PM »

I'm using the mach 3 n my plasma table, everything seems to work ok, but when I try to edit a g code, it just doesn't open the editor window, it appears a little window for a second and it says "path generation", and disappears, can anyone help me understand this issue?

Thanks.