Hello Guest it is March 28, 2024, 11:55:41 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - artsygraver

Pages: 1
1
Just wanted you to know fixing those settings worked!!
Now it runs fine in the Mill software, and the motors no longer get hot.

Thanks!! ;D

2
Thanks Hood.
I'll give it a try tonight.

3
Thanks for your Reply Hood!

What should be in the step port and dir port boxes?

4
General Mach Discussion / 3020T-DJ runs in TURN software but not MILL
« on: August 01, 2013, 11:54:18 AM »
Hello everyone!
I just purchased a 3020T-DJ from Amazon and have been getting used to it.
The wierd thing is it will run a job in the Turn software, but not the Mill.
In the Mill software, it won't jog, or goto manually typed coordinates. All it does is the motors get hot.
But If I run - for example - the roadrunner job in Turn, it works fine.
Any Ideas?
I am attaching my configuration xml.

I am using Mach3 ver 2.something that came with the machine.

Thanks!

Pages: 1