Messages

1

General Mach Discussion / Re: USB set up help?

« on: May 10, 2020, 08:13:30 AM »

Thank you.

2

General Mach Discussion / USB set up help?

« on: May 09, 2020, 07:46:23 AM »

Hello,

 I had a old C10 board and sold all the components but an still using the old windows XP with mach 3 version R3.043.066.  Now i just purchased a USB BOB and looking for the settings. I am still using the old windows XP system. Every time I go to motor turning tab and mess with the settings says ERROR FOUND, Art Code 9991, Attempt recovery. Error triggered . I click yes and nothing, I click No and the program crashes.

Any help would be much appreciated.

3

General Mach Discussion / Re: Threading problem?

« on: April 15, 2015, 12:37:25 PM »

Sorry. Here it is.

4

General Mach Discussion / Re: Threading problem?

« on: April 15, 2015, 11:32:32 AM »

thanks

5

General Mach Discussion / Re: Threading problem?

« on: April 15, 2015, 09:07:16 AM »

It's not letting me attach the file. Tried to rename it ect.

6

General Mach Discussion / Re: Threading problem?

« on: April 15, 2015, 01:46:14 AM »

Is there any other literature you could link me to to figure this out. I guess I am not understanding it.

7

General Mach Discussion / Re: Threading problem?

« on: April 08, 2015, 04:24:40 PM »

Now when I set the spindle rpm for 300 it says over max feedrate even when setting at different speeds. It will post when I set it for 50 RPM, but my lathe wont go that low....?

8

General Mach Discussion / Threading problem?

« on: April 08, 2015, 12:47:40 AM »

Hello all,

 I've seem to hit a bump in the road. I've been using mach 3 for quite some time now and am now starting to do threading I went through all the literature for mach3 turn for threading. to do 32 TPI.  However: when I post the code there's a red line that my machine follows. I thought that red line was homing or start point, is this correct? I have posted a pic any help would be much appreciated.

9

General Mach Discussion / Re: lathe motor conversion?

« on: March 10, 2015, 03:07:10 AM »

I'm looking at this NEMA 23 Closed Loop Stepper Motor System-Hybrid Servo Kit, 32 bit DSP Based automation technologies inc. Would you suggest this?

10

General Mach Discussion / Re: lathe motor conversion?

« on: March 07, 2015, 06:25:34 AM »

Thanks