Hello Guest it is March 28, 2024, 05:19:47 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - malco55

Pages: 1
1
General Mach Discussion / mach 3/techno cnc
« on: July 11, 2013, 09:41:40 AM »
Hello,
  I am new to this forum hopefully somebody can point me in the right direction.  We recently dug out the older Techno isel cnc router that was sitting in the corner of our shop.  I dont know a whole about this so bare with me.  We are attempting to upgrade the controlling computer of this machine and run it off Mach 3.  We installed mach3 hooked everything up and have no communication with the router.  Has anybody attempted this or completed this?  Will this even work or do i have to reengineer the wheel a little bit?  any info would be greatly appreciated! 

Pages: 1