Hello Guest it is November 28, 2021, 03:08:56 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 21St Century

Pages: 1
1
Share Your GCode / trying to cut a bushing but....
« on: July 09, 2013, 07:50:05 PM »
So i am trying to mill out a 4" circle  with a 3" circle inside but i cant write a G code to cut a Full circle. this is what i have.

g0 x0 y0
g01 z-1
g02 x1.5 y0 r-1.5

sure could use a little help here

Pages: 1