Guest
Show Posts
1
General Mach Discussion / NFS wizzard Gear cutting
« on: November 21, 2015, 12:02:46 PM »
Hi,
I use Mach3 for some years, but now I have a 4th axis I want to cut Gears.
When I set up the job all seems to work fine except the feeding of the Y axis in the material.
When I look to the G code de Y speed is the same as the Material number, so when I choose Aluminum, the feed is 1 when I use Other , the feed is 9, that is still very slow.
Is this a known bug?
Tanks for Answer.
Rien pa3gmi
I use Mach3 for some years, but now I have a 4th axis I want to cut Gears.
When I set up the job all seems to work fine except the feeding of the Y axis in the material.
When I look to the G code de Y speed is the same as the Material number, so when I choose Aluminum, the feed is 1 when I use Other , the feed is 9, that is still very slow.
Is this a known bug?
Tanks for Answer.
Rien pa3gmi