Hello Guest it is March 28, 2024, 08:28:48 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - emi

Pages: 1
1
FAQs / Re: Setting up a 4th Axis (new to CNC)
« on: July 01, 2013, 08:18:32 AM »
I have older version i just solve my issue by updating thanks.

2
FAQs / Re: Setting up a 4th Axis (new to CNC)
« on: July 01, 2013, 07:47:25 AM »
hey i have question about slave axis how do i get these option for X Y Z
 my setup only have one option primary xyza- none and slave xyza-none.
Your screen shows A B C AXIS also?

3
General Mach Discussion / Mach3 setup for 4axis hot wire
« on: June 27, 2013, 04:43:10 PM »
Hey i need help with  setting up 4axis hot wire I'm
using g540 gecko 4axis setup.
 I have X and A as a slave i can jog 2 motors with up or down arow
How do i slave Y and B axis so i can jog in sync with lets say arrow key?
i did try sys hotkeys set same key for Y y++38 y-40 B b++38 b-40 no results only one motor moves
Did try formulas  put f(y)=b still nothing.
amateur at best need help!

Pages: 1