Hello Guest it is March 28, 2024, 08:29:08 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Heflin

Pages: 1
1
General Mach Discussion / Re: Upgrading controller to Mach3
« on: June 06, 2015, 10:25:34 PM »
Hey galcorn, any luck on the conversion/upgrade. Very interested as I recently purchased an older AXYZ machine. I have a computer with the Toolpath for Windows software but no way to run 3d nc files from Vcarvepro. I am looking at a conversion so that I can run Mach and wondering the best way to proceed and hoping that those who have gone before me can shed some light on the correct trail. Thanks in advance, Heflin

Pages: 1