Messages

1

CS-Lab / missing encoder pulses with the ip-a

« on: December 23, 2015, 03:37:48 AM »

Hi Jonathon,
I would look for a mechanical issue first. I think if the controller or drive was out, it would be out all the time. Have a look for loose coupling/pulleys. Check all grub screws.


Alan

2

CS-Lab / Position creep in all three axis / csmio/ip-a

« on: October 16, 2015, 09:25:41 PM »

Volt ohm meter. Multimeter.


Alan

3

Brains Development / Machine status light

« on: October 04, 2015, 10:03:33 AM »

Hi, as an example. Have a look at the one on CS-Labs website. I have it running on my machine without any problems.
http://www.cs-lab.eu/en/index.php?m=article&s=main&aid=131&uinfo=Macro_for_A_Signal_Tower



Alan

4

Mach3 and G-Rex / Mach3 Probe HELP

« on: October 04, 2015, 08:53:39 AM »

Hi, have you assigned the probe in ports and pins?


Alan

5

General Mach Discussion / Hood's Birthday tomorrow: Happy birthday Hood

« on: April 11, 2015, 09:05:51 AM »

Happy Birthday Hood. Hope it's a peaceful one. With not too much time answering people's questions. And more time making things. 


Alan

6

CS-Lab / defective Plugin Found ignoreing

« on: March 20, 2015, 04:41:16 AM »

Hi Jun, make sure you are using the correct plugin. I have the ip-s running on both Mach3 good, and Mach4 with some slight issues. These issues will settle down once mach4 stops changing on a weekly basis. I'm away from home at the moment but will let you know the correct files you need in mach3 and the firmware you need in the ip-s. Should be home Tuesday.
Best regards


Alan

7

CS-Lab / defective Plugin Found ignoreing

« on: March 19, 2015, 06:35:35 AM »

Hi Jun,
Is it running mach3 or mach4?


Alan

8

Brains Development / Running a Script from a Brain in MACH3 - is this fixed?

« on: January 19, 2015, 05:19:31 AM »

Hi Simpson36,
If the customer has a Macropump running, include your pump in there file. I have done it successfully on my machine with several totally unrelated things.


Alan

9

CS-Lab / Mach3 + CS LAB Ethernet 32 or 64 Bit??

« on: January 07, 2015, 06:53:00 AM »

Hi FredMazak,
I'm running a Csmio ip-s controller on a 64 bit windows 7, and both Mach3 and 4 run fine. I have several VB scripts running without any problems on Mach 3. Mach 4 has a small glitch with m3/m4 not starting the spindle. But the spindle on/off button works ok. M3/M4 sends the 0-10v to drive but it doesn't activate the output.
Hope this helps.



Alan

10

CS-Lab / CSMIO/IP-S vs DELTA ASDA-B2

« on: December 15, 2014, 06:44:33 AM »

Holly snapping duck *********! That is bloody awesome. Is that the 929 long spindle. I have the 915 short.


Alan