Hello Guest it is March 28, 2024, 12:44:17 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - magnetron

Pages: 1 2 3 4 »
1
Modbus / Mach3 modbus TCP to STM32F4 uC - help
« on: October 07, 2023, 01:47:01 PM »
hi dear forum members,

I am trying to modbus TCP connect MACH3 to STM32F4 uC

these are  the wireshark capture of the TCP traffic and the MACH3 test page

MACH3 connects and gives No error message to STM32

as you can see when I write to 2 holding registers the response from STM32 checksum is correct
however MACH3 gives Receive Timeout

what am I doing wrong , please advise

thank you




2
I still need help about this problem - thank you

3
You can load the copycat screen and remove the Rem( ' ) out of each buttons VB code for A & B axis.

hello thank you - where can I find the VB script for copycat ?

4
hello dear forum,

for an application I need to "teach in" koordinates of 5 axis into G-code file

however copy cat plugin teaches ony 3 axis ?

what can I do ?

thank you

5
Brains Development / is there a way to set / reset an output in brains ?
« on: December 05, 2019, 06:52:40 AM »
hello dear forum,

I want to set / reset an output within brains

how do I do it ?

thank you

6
first of all I wont use MODBUS RTU
I want use MODBUS TCP
second I want make my own controller in order to earn money
I dont want to write my own MODBUS TCP stack
I want use the one of MACH3
thats why I am asking if it is posible to access
step pulses from within Brains
it will make my development job easy
without necessary to write a plugin for my own board

7
hello dear forum,

I want access the pulse counts of XYZ axes from within brains in MACH3

what are the relative names of the variables of pulse counts of each axes ?

for example the 10 successive pulse counts of X axes every 1/10 second
( assuming MACH3 updates 10 successive puls counts every 1/ 10 sec )

I want send this pulse counts to MODBUS TCP for own made motion card
to drive step motors 

thank you

8
hello dear forum,

I want access the pulse counts of XYZ axes from within brains in MACH3

what are the relative names of the variables of pulse counts of each axes ?

for example the 10 successive pulse counts of X axes every 1/10 second

thank you

9
General Mach Discussion / has anyone used this paralel port board ?
« on: October 04, 2018, 11:10:35 AM »
hello dear forum,

I want to use this board for paralel port



I want to ask if anyone used this board before ?

can I use the limit switch inputs for homeing axes ?

the board is a product of stepperonline

thank you

10
hello again ,

now I need to download "Mach plugin wizard"

please the link becouse I couldnot find it anywhere ( if available for win10 )

thank you

Pages: 1 2 3 4 »